Rod holder deck mounting stainless steel ARBO-INOX

The rod holder is made of high quality stainless steel(AISI 316) and could be mount into the deck. It possess a plate which could be stick anywhere on board through four screws, while the rod holder itself(the pipe) could be stick and remove all the time.The top of the rod holder is made out of rubber so that the rod is not turning around. measurements: length of pipe:220mm diameter of the pipe :50mm width of the plate: 91mm length of the plate:91mm

The rod holder is made of high quality stainless steel and could be mount in a 30° angle. It contains a gimbal lock which prevent the rod from turning inside of the holder. The rod holder is in the inside made of rubber, this guarantees that the rod is not falling out of the holder. measurements: mainplate length.106mm width:85mm pipe-Ø:50mm mounting depth:240mm three drillings to stick the holder (Ø:7mm)

Fishing rod holder made of stainless steel (V4A) for deck mounting.360° turnable with different angle options. It is naturally steady against water and ultraviolet radiation. In the inside it is made out of rubber so that the rod is not able to turn. measurements: base-length:91mm base-width61,5mm length:365mm pipe -Ø:51mm four drillings-Ø:6mm

Spare cap for the swiveling rod holder with item number: 009898 This offer applies exclusively to the replacement cap made of rubber and not for the fishing rod holders. The fishing rod holder can be found in our shop.

The rod holder is made of high quality stainless steel and could be mount into the deck in a 90° angle. It contains a gimbal lock which prevent the rod from turning inside of the holder.It also contains a protection cap wich protects the pipe. The rod holder is in the inside made of rubber, this guarantees that the rod is not falling out of the holder. measurements: mainplate length.106mm width:85mm pipe-Ø:50mm mounting depth:240mm three drillings to stick the holder (Ø:7mm)

The rod holder is made of high quality stainless steel and could be mount in a 30° angle. It contains a gimbal lock which prevent the rod from turning inside of the holder. The rod holder is in the inside made of rubber, this guarantees that the rod is not falling out of the holder. measurements: mainplate length.106mm width:85mm pipe-Ø:50mm mounting depth:240mm three drillings to stick the holder (Ø:7mm)

The rod holder is made of high quality stainless steel and could be mount in a 30° angle. It contains a gimbal lock which prevent the rod from turning inside of the holder. The rod holder is in the inside made of rubber, this guarantees that the rod is not falling out of the holder. mainplate length:115mm width:87mm pipe-Ø:50mm mounting depth:240mm three drillings to stick the holder (Ø:7mm)